orange bridesmaid dresses_How to Make a Silk Wedding Stem Bouquet_sexy wedding dress

 Cut the floral wire with wire snips to make one thick piece for each flower and one thin piece for each leaf. Make each piece of wire slightly longer that the stem of the item into which it will be inserted. Push each piece of wire into the corresponding stem up through the lower end.

Wrap each wired stem with floral tape. Begin wrapping at the top of the stem.close to the head of the flower or leaf. Spin the stem as you wrap so that each layer of tape slightly overlaps the last.Trim off excess tape with scissors.

Remove the lowest four or five leaves of each bunch of foliage. Wrap the stems of the silk foliage with the smaller wire using the same process that you did to tape the other stems. Cover the wire with floral tape by taping the foliage stems just as you did the others.

Use scissors to cut lengths of ribbon that will trail from the bouquet. Make them as long as you desire.plus two inches. Fold one end of each ribbon into a point approximately two inches long; wrap these points with floral tape so that they create a \"stem\" for the ribbons.

Pick up a piece of the foliage and hold it in your dominate hand. Place one of your flower choices approximately halfway down the foliage. Press the wires firmly together and wrap them with a small amount of floral tape.

Hold the beginning of the bouquet in your dominant hand and pick up another piece of prepared foliage with the other. Position this greenery approximately halfway up the stem of the attached flower. orange bridesmaid dresses Bend the wires you taped together previously backward to create a handle orange bridesmaid dresses

Wrap the three stems together with a bit of tape.stopping at the bend in the first two wires. Use scissors to trim away excess tape.and wire snips to cut away the rest of the wired stem of the new piece of greenery. Gently bend up the greenery to begin filling out the bouquet.

Add more greenery around the sides and top of the bouquet.using the same procedure as before. Attach each piece with the floral tape and trim away any length of stem that goes past the bent \"handle\" of the bouquet. Fluff up the foliage so that the sides of the bouquet appear full.

Insert one of the type b flowers through the center of the circle of foliage from the front. Pull the wire completely through the back. Continue filling the empty center of the greenery ring with flowers this way.staggering the type a and type b blossoms so that the arrangement looks random.

Bend the wired stems of the flowers so that they group with the original \"handle\" stems. Wrap all of the stems with a thin layer of floral tape to hold them together. Fill in any empty spaces in the bouquet with wired leaves or more greenery.attach them with floral tape.and cut away extra stem lengths.

Hold the bouquet in your non-dominant hand. Use your dominant hand to insert the \"stems\" of the trailer ribbons along the bottom of the bouquet so that they are even with the handle in the back and the ribbons fall naturally in the front. Wrap the taped ends of the ribbons and the handle of the bouquet together with a small amount of the tape.

Make any adjustments by bending pieces in different directions or fluffing them. Finish the ends of the trailing ribbons by cutting them into points.hemming them.typing them into love knots or whatever you wish. Hold the bouquet with the flowers faced down and the sexy wedding dress handle up. Shake the bouquet gently to release any dust or loose pieces to complete your silk wedding sexy wedding dress